TM  10-3930-643-34 HYDRAULIC  SYSTEM  TROUBLESHOOTING  AND  MAINTENANCE. 12-9. Tilt Cylinder. (Sheet 9 of 10) INSTALLATION 56. Coat pin (14), washer (13) and bolt (12) with grease. 57. Using a 1-1/8” socket and socket wrench  handle,  install  pin (14), washer (13) and bolt (12). 58. Install new preformed packing (11). 59. Connect hose assembly (10). 60. Using a 9/16” socket and socket wrench  handle,  install two  flange halves (9) and four bolts (8). 61. Install 62. Connect 63. Using a install 64. Using a handle, new preformed packing (7). tube assembly (6). 5/16” socket head screw key, two bolts (5 and 4). 3/4” socket and socket wrench install bracket  assembly  (3), two washers (2) and bolts (l). 65. Remove hoist and sling from cylinder assembly (20). 66. Operate  engine  until  hydraulic  fluid is at normal operating temperature. 67. Move tilt control lever to tilt back position until rod is fully extended. 68. Apply Loctite 262 to three washers (22) and bolts (21). Go to sheet 10 12-73