TM  10-3930-643-34 HYDRAULIC  SYSTEM  TROUBLESHOOTING  AND  MAINTENANCE. 12-9. Tilt Cylinder. (Sheet 3 of 10) REMOVAL 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Remove  and  discard  preformed  packing (7). Using a 9/16” socket and socket wrench handle, remove four bolts (8) and two flange halves (9). Disconnect  hose  assembly  (10). Remove  and  discard  preformed  packing (11). Using a 1-1/8” socket and socket wrench  handle,  remove bolt (12), washer (13) and pin (14). Using a 9/16” open end wrench, disconnect  hose  assembly  (15). Using a 1/2”   open and box end wrench,  remove  adapter  (16)  from vehicles S/N  2000 and below,  only. Using a 1-1/8” socket and socket wrench  handle,  remove bolt (17), washer (18) and pin (19). Using  hoist  and  sling,  remove cylinder  assembly  (20)  and  shims (20a) from vehicle. Place cylinder assembly (20) on a suitable work bench and remove hoist and sling. Go to sheet 4 12-67