| |
TM 10-3930-643-34
FRAME AND TOWING ATTACHMENTS MAINTENANCE.
10-2.
Frame Hinge Pin and Frame Assembly. (Sheet 2 of 13)
CHECKING HINGE PIN WEAR
1.
Position vehicle on level ground.
NOTE
Place the dial indicator in a
position that will allow another
person to observe the readings
from the side of the vehicle at a
safe distance.
2.
Position dial indicator as close as
possible to the hitch pin at the
lower frame hitch and zero dial
indicator.
Only a qualified operator may
perform the next step. All other
personnel, with the exception of
an observer for reading the
dial
3.
4.
5.
6.
7.
8.
9.
indicator,
must
clear
the
immediate area. Failure to follow
this procedure could
result in
SEVERE INJURY or DEATH.
Power forklift down until front
wheels are off ground.
Read dial indicator.
Raise forklift to full
Read dial indicator.
height.
If readings
indicate an up and down movement of
more than 0.010 inch, adjustment or
replacement is necessary.
Install safety lock bar, refer to TM
10-3930-643-10.
Lower forklift to ground.
Stop engine.
Go to sheet 3
10-7
|
