TM 10-3930-643-34 STEERING  TROUBLESHOOTING  AND  MAINTENANCE.  (cont) 9-5 l Steering Cylinder. (Sheet 5 of 5) ASSEMBLY  (cont) 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. Install  new  preformed  packing  (4) on piston (5). Install one of two rings (2), closest to gland (11) on piston (5). Place seal (3) in hot water 180-200 degrees F to soften and install over preformed  packing  (4). Using  a  ring  compressor,  compress seal (3) and ring (2) onto piston (5). Using  a  rubber  mallet,  install  items 5 thru 2 as an assembly on rod (13), keeping items 3 and 2 compressed. Apply Loctite 592 to threads of rod (13) and using a 1-13/16" socket, socket  wrench  handle  and  torque wrench,  install  nut  (1).  Tighten nut (1) to 370 lb-ft. Using  a  lint  free  cloth,  lubricate items 11 thru 6 as an assembly and items 5 thru 2 as an assembly. Tap items 13 thru 2 as an assembly into cylinder (15), until seal (3) is inserted in barrel. Apply  Loctite  592  across  width  of cylinder  (15)  housing  threads. Using a cylinder cap tool and torque wrench,  tighten  cap lb-ft. NOTE Return  M10A  Forklift equipment  condition. (12) to 950 to original END OF TASK 9-36