TM 10-3930-643-34 STEERING  TROUBLESHOOTING  AND 9-3. Ground  Driven  Steering ASSEMBLY 53. 54. 55. 56. 57. 58. 59. 60. 61. 62. 63. 64. MAINTENANCE. Pump (S/N 2000 Using a hammer and small punch, install two pins (21) and gears (20). Using a flat tip screwdriver and small punch, install plate (18), two screws (17), pins (16) and body (15). Using a hammer and small punch, install two bearings (14) and pins (13). Using  retaining  ring  pliers,  install two rings (11). Install new preformed packing (12). Position items 19 thru 12 as an assembly. Apply Loctite 262 under bolt heads only. Using a 9/16" socket, socket wrench  handle  and torque wrench, install four bolts (10 and 9). Tighten bolts (10 and 9) to 34 lb-ft. Using  a  flat  tip  screwdriver,  install adapter (8) and plug (7). Install locating ring (6) and new preformed  packing  (5). Using  retaining  ring  pliers,  install new seal (4), ring (3) and new seal (2). Position items 8 thru 2 as an assembly. Apply Loctite 262 under bolt heads only. Using a 7/16" socket, socket wrench  handle  and torque wrench, install three bolts (1). Tighten three bolts (1) to 24 lb-ft. NOTE Return M10A Forklift to original and below). (Sheet 10 of 10) equipment  condition. END OF TASK 9-23