| |
TM 10-3930-643-34
GENERAL MAINTENANCE PROCEDURES.
2-13.
Electrical Repairs.
(9) Multi-wire connector, compression type.
DISASSEMBLY
1.
Loosen compression nut from shell assembly.
2.
Slide compression nut and spanner nut up on wire to expose pin and socket
terminals.
NOTE
All wires must be tagged when removed
whether wire is connected to pin-type
from
connector.
Indicate
or socket-type connector.
3.
Cut wire close to terminals.
Remove and discard terminals.
4.
Remove and discard shell assembly, spanner nut and compression nut.
ASSEMBLY
1.
2.
3.
4.
5.
Slide new compression nut and new spanner nut onto wire.
Strip wires, refer to Wire Size Chart. Do not cut or nick strands.
Tin bare wires.
Use resin-core solder to coat bare wires.
If using
solid core solder, clean wires with flux before tinning.
Insert wires into connector pins or socket wells as indicated on tags.
Secure wires and new terminals to prevent movement and solder.
Use
solder sparingly.
2-25
|
