| |
TM 10-3930-643-34
GENERAL MAINTENANCE PROCEDURES. (cont)
2-13.
Electrical Repairs. (cont)
(8) Multi-wire connector, hard shell.
DISASSEMBLY
1.
Loosen two screws until wire is free to rotate.
2.
Remove terminal assembly from shell.
NOTE
All wires must be tagged when removed from connector.
Indicate
whether wire is connected to pin-type or socket-type terminal.
3.
Cut wires close to terminals. Discard terminals.
4.
Record location of terminals.
5.
Remove and discard shell.
ASSEMBLY
1.
Strip wires, refer to Wire Size Chart. Do not nick or cut strands.
2.
Tin bare wires. Use resin-core solder to coat bare wires.
If using
solid core solder, clean wires with flux before tinning.
3.
Slide new shell onto wires.
4.
Insert wires into connector pins or socket wells as indicated on tags.
5.
Crimp wires.
Securely fasten wires to new terminals.
6.
Secure wires and new terminal to prevent movement and solder. Use solder
sparingly.
2-24
|
