TM  10-3930-643-34 GENERAL  MAINTENANCE  PROCEDURES.  (cont) 2-13. Electrical  Repairs.  (cont) (6)  Ring-type  connector,  soldered. DISASSEMBLY Cut wire close to terminal. Remove  and  discard  terminal. ASSEMBLY NOTE New terminal must be selected to match the ring size of the terminal with the mounting screw at the connection. New terminal must also match the wire solder area with the size of the wire. 1. 2. 3. 4. 5. Strip wire, refer to Wire Size Chart. Do not cut or nick strands. Tin bare wires. Use resin-core solder to coat bar wires. If using solid core solder, clean wires with flux before tinning. Insert wires in new terminal. Secure wires to new terminal. Fill wire cavity with melted solder. Allow to cool several minutes before moving wires or new terminal. 2-22