| |
TM 10-3930-643-34
GENERAL MAINTENANCE PROCEDURES.
2-13.
Electrical Repairs.
DISASSEMBLY
NOTE
All wires must be tagged when removed from connector.
Indicate
whether wire is connected to pin-type or socket-type terminal,
refer
to illustration.
1.
Using pin removal tools, push connector terminals out of connector.
2.
Record location of terminal.
3.
Remove and discard terminals.
ASSEMBLY
1.
Strip wires, refer to Wire Size Chart. Do not nick or cut strands.
2.
Tin bare wires. Use resin-core solder to coat bare wires.
If using
solid core solder, clean wires with flux before tinning.
3.
Insert wires into new terminals.
Make sure pin-type and socket-type
terminals
4.
Crimp new
5.
Using pin
required.
are used as required.
terminals. Securely fasten new terminals
insertion tools, install new terminals in
to wires.
holes of connector as
2-21
|
