| |
TM 10-3930-643-34
BRAKE TROUBLESHOOTING AND MAINTENANCE. (cont)
8-7.
Pressure Converter (S/N 2001 and above). (Sheet 5 of 5)
INSTALLATION
11.
12.
13.
14.
15.
16.
17.
18.
Using a 13/16” open end wrench install
tee (20) on left side pressure
converter (13) only.
Using a 9/16” and 7/8” open end
wrenches , install elbows (19 and 18).
Using a 5/8”
nipple (17),
(15).
Using a 3/4”
open end wrench, install
elbow (16) and adapter
socket, socket wrench
handle, and a 3/4” box end wrench,
install pressure converter (13),
two washers (12), bolts (11),
washers (10), nuts (9) under front
of vehicle.
Connect two wire assemblies (8) at
terminals on left side pressure
converter (13) only.
Apply sili-
cone sealant over entire connection.
Using a 3/8” open end wrench, install
two washers (7) and nuts (6) on
terminals of left side pressure
converter (13) only.
Using 5/8”, 1/2”
and 7/8” open end
wrenches, connect tube assemblies (5
and 4) and hose assemblies (3 and 2).
Connect wire assembly (1) at
terminal.
Apply silicone sealant
over entire connection.
SERVICE
19.
If after servicing brake system the
brake warning light goes on and
stays on, reset indicator rod
back
in place with a length of wire.
Indicator rod has no resistance and
light will go off.
NOTE
Return M1OA Forklift
equipment condition.
8-30
to original
END OF TASK
|
