| |
TM 10-3930-643-34
GENERAL MAINTENANCE PROCEDURES.
2-13. Electrical Repair.
(1) Terminal-type connector, with shell.
1.
2.
3.
4.
5.
6.
7.
8.
9.
DISASSEMBLY
Cut wire close to shell.
ASSEMBLY
Strip wire, refer to
Tin bare wires. Use
Remove and discard shell.
Wire Size Chart. Do not nick or cut strands.
resin-core solder to coat bare wires.
If using
solid core solder, clean wires with flux before tinning.
Strip new wire, refer to Wire Size Chart. Do not nick or cut strands.
Tin bare wires. Use resin-core solder to coat bare wires.
If using
solid-core solder, clean wires with flux before tinning.
Slide shrink tubing on wire before splicing.
Splice wires.
Twist together tightly.
Secure wires to prevent movement and solder.
Position shrink tubing over spliced wire.
Apply heat to shrink tubing.
Shrink until tubing fits snuggly.
2-17
|
