TM  10-3930-643-34 FRONT  AND  REAR  AXLES  TROUBLESHOOTING  AND  MAINTENANCE. 7-7. Rear Axle Assembly (S/N 2000 and below). (Sheet 3 of 7) REMOVAL NOTE Tag all hose and tube assemblies before disconnecting to aid in installation. 5. Using a 7/16”   open end wrench, remove tube assemblies (14). 6. Using a 3/4”   socket,  socket wrench handle and a 3/4” open end wrench, remove bolt (15), washer (16) and clamp (17). Use  transmission  and  differential lift for removal and installation. Keep area clear of unnecessary personnel. Failure to follow this procedure could result in SEVERE INJURY. 7. Position  transmission  and  differe- ntial lift under rear axle assembly items 22 thru 45. 8. Using a 1-1/2” open end wrench, 1-1/2” socket and socket wrench handle, remove eight nuts (18), washers (19), bolts (20) and washers (21). 9. Using  a  transmission  and  differential lift, a hammer and flat tip screw- driver, remove rear axle assembly items 22 thru 45. 10. Place rear axle assembly items 22 thru 45 on wood blocks and remove transmission  and  differential  lift. 11. Remove differential (22), refer to paragraph 7-9. GO to sheet 4 7-41