TM  10-3930-643-34 FRONT  AND  REAR  AXLES 7-5. Front and Rear INSTALLATION 17. 18. 19. 20. 21. 22. 23. TROUBLESHOOTING  AND  MAINTENANCE. Planetary. (Sheet 6 of 8) Lubricate  new  ring  (26)  with  clean oil and install in wheel hub (27). Install cups (25 and 24). Using a 1-1/8” socket and socket wrench  handle,  install  disc  (23), 18 washers (22) and bolts (21). Aline  location  marks  with  wheel hub  (27)  during  installation. NOTE The  following  is  a  difference between  M10A  Forklift  models. Install bearing (20), new seal (18) and  retainer  (17)  on  vehicles  S/N 2001 and above or install bearing (21), ring (19), new seal (18) and retainer (17) in vehicles S/N 2000 and below. Apply Loctite 290 to lips of new seal  (18)  before  installation, then install items 27 thru 17 as an assembly on left side of rear axle assembly. Install bearing (16). Apply Loctite 262 to threads on eight bolts (12). Using a 1/2” socket and a torque wrench, install ring (14), four bars (13) and eight bolts (12) to hub (15). Tighten  eight  bolts (12) to 20 to 23 lb-ft. GO to sheet 7 7-29