| |
TM 10-3930-643-34
FRONT AND REAR AXLES
7-5.
Front and Rear
REMOVAL
TROUBLESHOOTING AND MAINTENANCE.
Planetary. (Sheet 2 of 8)
NOTE
The following is a procedure for
removal/installation of left side
rear planetary carrier
assembly.
The procedure for right rear and
front left and right planetary
assemblies is identical.
1.
Using a 9/16” open and box end
wrench, remove two bolts (1) from
rear, left side of axle assembly.
2.
Using a 9/16” socket, socket
wrench
handle and a putty knife,
remove
eight bolts (2), washers (3),
cover
(4) and gasket (5). Discard gasket
(5).
Remove all gasket material from
mounting surfaces.
Weight of planetary carrier assem-
bly is approximately 180 lbs. Use
adequate hoist
and
sling
for
removal and installation.
Keep
area
clear of
unnecessary
personnel.
Failure to follow this
procedure could result in SEVERE
INJURY.
3.
Attach hoist and sling to planetary
carrier assembly (6) and remove.
Place securely on ground.
Go to sheet 3
7-25
|
