| |
TM 10-3930-643-34
TRANSMISSION TROUBLESHOOTING AND MAINTENANCE. (cont)
6-6.
Transmission Assembly. (Sheet 11 of 12)
INSTALLATION (cont)
80.
Using a 1-3/8" open end wrench,
install adapter (14).
81.
Using a 1-1/2" open end wrench,
connect hose
transmission
Tighten bolts
82.
Using a 3/4"
assembly (13) under
(53).
NOTE
finger tight only.
socket and socket wrench
handle,
install plate (12), two
washers (11) and bolts (10).
NOTE
Tighten bolts finger tight only.
83.
Install plate (9), two washers
(8)
and bolts (7).
NOTE
Clearance should be 1/16 inch.
If clearance is less, plate must
be replaced.
If clearance is
1/16 inch, torque bolts to 80
lb-ft .
84.
85.
86.
87.
88.
89.
Go to
6-46
Using a
feeler gage, measure
clearance between plates (9 and
12)
and support block.
Using pipe wrench, install elbow (6),
nipple (5) and gage (4) at right side
of transmission (53).
Using a 1-3/8" open end wrench,
install elbow (21).
Connect hose assembly (20).
Using a flat tip screwdriver,
tighten clamp (19).
Position hanger bearing propeller
shaft from transmission front out-
put yoke to rear of transmission (53).
sheet 12
|
