| |
TM 10-3930-643-34
TRANSMISSION TROUBLESHOOTING
6-6.
Transmission Assembly.
INSTALLATION
AND MAINTENANCE.
(Sheet 8 of 12)
49.
Using a 3/4"
socket, socket
wrench
handle and a 3/4" open end wrench,
install bracket (61), seven
washers
(60)9 bolts (59), washers (58) and
nuts (57) in transmission (53).
50.
Using a 3/4"
socket and socket wrench
handle, install bracket (56),
eight
washers (55) and bolts
(54) in
transmission (53).
WEIGHT HAZARD
Weight of transmission assembly
51.
52.
53.
54.
55.
is approximately 730 lbs.
Use
adequate hoist and
cable for
installation.
Keep area clear of
unnecessary personnel.
Failure
to follow this procedure
could
result in SEVERE INJURY.
Position transmission (53) underneath
vehicle.
Attach cable to lifting eye on top of
transmission (53) and lifting eye
installed in floor plate (1) of cab.
Using hoist and chain, raise trans-
mission (53) up, pushing it to rear
of vehicle, clearing the left side.
Position pins on brackets (56 and
61) into pin supports in vehicle
rear frame.
Remove hoist, cable and lifting eye
from top of transmission (53).
Using a 1-1/8" socket and socket
wrench handle, install
new gasket
(52) and plug (51) in top of
transmission (53).
6-43
|
