TM  10-3930-643-34 TRANSMISSION 6-3. Torque INSTALLATION 32. 33. 34. 35. 36. 37. 38. 39. 40. TROUBLESHOOTING  AND  MAINTENANCE. Converter. (Sheet 7 of 9) Position torque converter (28) on flywheel  housing. Using a 9/16” socket, socket wrench handle,  and 1/2” torque wrench, install torque converter (28) and 12 bolts (27). Tighten bolts (27) to 33 then to 37 lb-ft. Install two new tie straps on hoses,  removed  to  gain  easier access to torque converter  (28). Using a 1-1/2"   open end wrench, install new preformed packing  (26) and plug (25). Position drive shaft (24). Using a 1/2”   socket,  socket wrench handle  and 1/2” torque wrench, install four locknuts (23) and bolts (22). Tighten bolts (22)  to  20 lb-ft. Install new preformed packing (21). Position hose assembly  (20). Using a 9/16” socket and socket wrench  handle,  install two  flange halves (19) and four bolts (18). to sheet 8 6-17