| |
TM 10-3930-643-34
TRANSMISSION
6-3.
Torque
REMOVAL
19.
20•
21.
22.
23.
24.
25.
26.
27.
Using a
TROUBLESHOOTING AND MAINTENANCE.
Converter. (Sheet 5 of 9)
9/16”
socket
and
socket
wrench handle, remove four bolts (18)
and two flange halves (19).
Disconnect hose assembly (20).
Using long round nose pliers, remove
and discard preformed packing (21).
Using a 1/2” open end wrench,
remove four bolts (22) and locknuts
(23).
Using a flat blade screwdriver or pry
bar, disconnect drive shaft (24).
Using a 1-1/2" open end wrench, remove
plug (25) and preformed packing (26).
Discard preformed packing (26).
Using side cutting pliers, cut and
discard two tie straps and separate
hoses for easier access to torque
converter (28).
Weight of torque converter is
approximately 180 lbs.
Use
adequate hoist
and
sling
for
removal and installation.
Keep
area
clear of
unnecessary
personnel.
Failure to follow this
procedure could result in SEVERE
INJURY .
Install one inch eyebolt in plug
mounting hole;
attach hoist and
sling.
Using a 9/16” socket and socket
wrench handle, remove 12 bolts
(27)
and torque converter (28). Use two
bolts (27) as pusher bolts near top
and bottom.
to sheet 6
6-15
|
