| |
TM 10-3930-643-34
TRANSMISSION TROUBLESHOOTING AND MAINTENANCE. (cont)
6-3.
Torque Converter. (Sheet 4 of 9)
REMOVAL (cont)
NOTE
All wire must be
tagged when
removed from connector.
Indicate
whether wire is
connected to
pin-type or
socket-type
connector.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
Using a flat tip screwdriver and
a 3/8" open end wrench, discon-
nect wire assemblies (4 and 5) at
terminals.
Using a 9/16” socket and socket
wrench handle, remove four bolts (6)
and two flange halves (7).
Disconnect hose assembly (8).
Using long round nose
and discard preformed
Using a 9/16” socket
wrench handle, remove
and two flange halves
pliers, remove
packing (9).
and
socket
four bolts (10)
(11).
Disconnect hose assembly (12).
Using long round nose pliers, remove
and discard preformed packing (13).
Using a 9/16” socket and socket
wrench handle, remove four bolts (14)
and two flange halves (15).
Disconnect hose assembly (16).
Using long round nose
and discard preformed
pliers, remove
packing (17).
Go to sheet 5
6-14
|
