| |
TM 10-3930-643-34
GENERAL MAINTENANCE PROCEDURES.
Section III.
DISASSEMBLY AND ASSEMBLY PROCEDURES
2-5.
Condition of Vehicle.
Before performing any maintenance task ensure that
the following conditions have been observed, unless otherwise specified.
a.
Forks must be lowered to the ground.
b.
Vehicle must be parked on level ground.
c.
Parking brake must be applied.
d.
Transmission must be in neutral and locked.
e.
Engine must be shut off.
f.
Master disconnect switch must be off.
g.
Components must be at operating temperature to be tested.
h.
Air system must be vented.
2-6.
Disassembly and Assembly Procedures.
Follow these general practices when
performing disassembly and assembly procedures:
a.
Read the procedure and thoroughly understand it before performing
maintenance or repair.
Be alert during procedure.
b.
Keep major components and assemblies together whenever possible and
practical.
c.
Tag hoses, electrical wires, cables and harnesses to identify them
and
aid in installation.
d.
Have all the necessary parts, tools, material and personnel before
starting procedure.
e. Keep related parts together for identification purposes.
f.
To prevent loss, temporarily reinstall attaching
hardware
such as
screws, bolts, washers and nuts.
g.
Only disassemble to point of problem.
h.
Make sure parts are clean and lubricated” before assembly.
2-5
|