| |
TM 10-3930-643-34
ELECTRICAL SYSTEM MAINTENANCE. (cont)
5-6. Fork Control Wiring Harness. (Sheet 4 of 4)
INSTALLATION
11.
12•
13.
14.
15.
16.
17.
18.
19.
20.
21.
Position harness assembly (13) on
right, front of vehicle.
Install new tie straps (12).
Connect wire assembly (11) at
connector to fork control valve.
Position lead assembly (10) on fork
control valve.
Using a 9/16” open end wrench,
install washer (9) and bolt (8).
Apply silicone sealant over entire
connection.
Using a 1/2” socket and socket wrench
handle, install three clamps
(7),
washers (6) and bolts (5).
Install new tie straps (4).
Connect lead assembly
(3) to
intermediate harness under right side
of cab.
Install clamp (2) on harness assembly
(13) in left side of operator’s
compartment.
Install new tie straps (l).
NOTE
Return M10A Forklift
equipment condition.
to original
END OF TASK
5-52
|
