| |
TM 10-3930-643-34
ELECTRICAL SYSTEM MAINTENANCE.
5-6.
Fork Control Wiring Harness. (Sheet 3 of 4)
REMOVAL
4.
5.
6.
7.
8.
9.
10.
Disconnect lead assembly (3) from
intermediate harness right side of
cab.
Using diagonal cutting pliers, cut
and discard tie
straps (4) from
right, front of vehicle.
Using a 1/2”
socket and socket wrench
handle, remove three bolts
(5),
washers (6) and clamps (7).
Using a 9/16”
open end wrench, remove
bolt (8) and washer (9).
Using a flat blade screwdriver,
disconnect lead assembly (10) from
fork control valve.
Remove wire
assembly (11) at
connector.
Using diagonal cutting pliers,
cut
and discard tie straps (12).
Remove harness assembly (13).
NOTE
Refer to paragraph 2-13 for
electrical repair procedures
for
harness terminals and connectors.
Go to sheet 4
5-51
|
