TM  10-3930-643-34 ELECTRICAL  SYSTEM  MAINTENANCE.  (cont) 5-6. Fork  Control  Wiring  Harness.  (Sheet REMOVAL NOTE   For the following procedures, disconnect is used to indicate the separation of plugs, connectors  or  terminals  and  the removal  of  all  attaching hardware. To prevent loss, reinstall  attaching  hardware  in its original position.   All electrical connections, except those on the instrument panel are sealed against moisture  with  silicone  sealant. Remove  all  silicone  sealant before  performing  maintenance  on electrical  connections. The quantity of tie straps used to secure harness is variable. 1. Using diagonal cutting pliers, cut and discard tie straps  (1)  in operator’s  compartment. NOTE All wire must be tagged when removed from connector. Indicate whether wire is connected  to pin-type  or  socket-type  connector. 2* Using a 1/2” socket and socket wrench handle,    remove clamp (2) from harness assembly (13) in left  side  of operator’s  compartment. 2 of 4) GO to sheet 3 5-50