| |
TM 10-3930-643-34
ELECTRICAL SYSTEM MAINTENANCE.
5-5.
Intermediate Wiring Harness (S/N 2000 and below). (Sheet 3 of 4)
REMOVAL
8.
Using a 9/16” open end wrench, remove
nut (8), washer (9) and clamp (10).
9.
Disconnect lead assembly (11) from
power cluster.
10.
Pull back two boots (12).
11.
Using a 3/8” open end wrench,
disconnect two lead assemblies
(13)
from power cluster.
12.
Using a flat tip screwdriver, remove
four screws (14) and washers
(15)
from operator’s compartment.
13.
Remove harness assembly (16) from
vehicle.
NOTE
Refer to paragraph 2-13 for
electrical repair procedures to
terminals and connectors.
INSTALLATION
14.
Position harness
assembly (16)
throughout vehicle.
15.
Using a flat tip screwdriver, install
four washers (15) and screws (14) in
operator’s compartment.
16.
Connect two lead assemblies (13) to
power cluster under left side of cab.
Apply silicone sealant over entire
connection.
17.
Pull two boots (12) over terminals.
18.
Connect lead assembly (11) to power
cluster.
19.
Using 9/16”
clamp (10),
open end wrench, install
washer (9) and nut (8).
Go to sheet 4
5-47
|
