TM  10-3930-643-34 ELECTRICAL  SYSTEM  MAINTENANCE.  (cont) 5-4. Intermediate Wiring Harness (S/N 2001 and above). (Sheet 4 of 4) INSTALLATION 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 5-44 Position harness assembly (16) throughout  vehicle. Using  a  flat  tip  screwdriver,  install four washers (15) and screws (14) in operator’s  compartment. Connect  two  lead  assemblies  (13)  to pressure  converter  under  left  side of cab. Apply  silicone  sealant  over entire  connection. Pull two boots (12) over terminals. Connect  lead  assembly  (11)  to pressure  converter. Using a 10” adjustable wrench, install clamp (10), washer (9) and nut  (8). Using a flat tip screwdriver, connect lead assembly (7) to transmission. Apply silicone sealant over entire connection. Pull boot (6) over terminal. Connect lead assembly (5) to ground driven  steering  pump  switch. Using a 9/16” socket and socket wrench handle, install clamp (4), washer (3) and nut (2). Connect  harness  assembly  (16)  to  main harness in left, front of hydraulic tank. Connect lead assembly (11) to pressure  converter  under  right  side of cab. Install a suitable number of new tie straps (1) to secure harness to vehicle. NOTE Return M10A Forklift to original equipment  condition.