| |
TM 10-3930-643-34
ELECTRICAL SYSTEM MAINTENANCE.
5-4.
Intermediate Wiring Harness (S/N 2001 and above). (Sheet 3 of 4)
REMOVAL
3.
40
5.
6.
7.
8.
9.
10.
11.
12.
13.
Disconnect harness assembly (16) from
main harness in left, front of
hydraulic tank.
Using a 9/16” socket and socket
wrench handle, remove nut (2), washer
(3) and clamp (4) under left side of
cab.
Disconnect lead assembly (5) from
ground driven steering pump switch.
Pull back boot (6).
Using a 9/16” open end wrench,
disconnect lead assembly (7) from
transmission.
Using a 10” adjustable wrench, remove
nut (8), washer (9) and clamp (10).
Disconnect lead assembly (11) from
pressure converter.
Pull back two boots (12).
Using a 3/8” open end wrench,
disconnect two lead assemblies (13)
from pressure converter.
Using a flat tip screwdriver, remove
four screws (14) and washers
(15)
from operator’s compartment.
Remove harness assembly (16) from
vehicle.
NOTE
Refer to paragraph 2-13 for
electrical repair procedures to
terminals and connectors.
Go to sheet 4
5-43
|
