| |
TM 10-3930-643-34
ELECTRICAL SYSTEM
5-3.
Main Wiring
MAINTENANCE. (cont)
Harness. (Sheet 13 of 15)
INSTALLATION (cont)
65.
66.
67.
68.
69.
70.
71.
72.
73.
Position wire assembly (28) in front,
left side of hydraulic tank,
Using a flat tip screwdriver, install
four washers (30) and screws (29).
Connect wire assemblies
(27) at
connectors.
Apply silicone sealant over entire
connection.
NOTE
The following is a difference
between M10A Forklift models.
Using a 9/16” socket and socket
wrench handle, install plate
(26),
four washers (25) and bolts (24),
from vehicles S/N 2001 and above, in
left side of
vehicle,
underneath
battery compartment.
Using a flat tip screwdriver, connect
wire assembly (23) at terminal to
sensor in left side of engine.
Apply silicone sealant over entire
connection.
Connect three wire assemblies (22) at
terminals to oil pressure switch.
Apply silicone sealant over entire
connection.
Go to sheet 14
5-38
|
