TM  10-3930-643-34 ELECTRICAL  SYSTEM  MAINTENANCE.  (cont) 5-1. Starting Motor.    (Sheet 11 of 15) ASSEMBLY  (cont) 57. 58. 59. 60. 61. 62. 63. 64. 65. If removed, press new bearing (57) into lever housing (58). Prior to installation,    soak bearing in oil, Grade  3. Soak wick (56) in oil, Grade 3. Then install new wick (56) and new cap (55). Lubricate bore of seal (53) lightly with oil, Grade 3, then install washer (54), new seal (53) and new preformed  packing  (52). Position items 58 thru 52 as an assembly  in  starting  motor housing (70). Aline match marks on lever housing (58) and starting motor housing (70). Using a 7/16” open end wrench, install five bolts (51). Using long round nose pliers, install plug (50). Install washer (49), lever (48) and drive  (47). Install armature (46). Install  new  preformed  packing (45), shaft (44), new preformed packing (43) and retaining ring (42). Go to sheet 12 5-12