| |
TM 10-3930-643-34
ELECTRICAL SYSTEM MAINTENANCE.
5-1.
Starting Motor. (Sheet 10 of 15)
ASSEMBLY
50.
51.
52.
53.
54.
55.
56.
Install terminal stud (69), if
removed, in coil (63).
Use soldering
gun and insulating tape.
Install insulator bushing (68) and
washer (67).
Using a cross tip screwdriver,
position two plates (66) and four
shoes (65).
Shoes (65) must be
assembled on coil (63) with long lip
in
the direction of
armature
rotation.
Long lip
must be the
trailing edge of the shoe, not
the
leading edge.
Wrap insulator (64) around coil (63).
Install coil (63) in starting motor
housing (70).
Support coil (63) by
hand or use pole shoe spreader.
Do not tear insulator.
Careful
installation of coil is necessary
to prevent shorting or
grounding
of the coil as shoes are tightened
into place.
Using a cross tip screwdriver,
install eight screws
(62) through
starting motor housing
(70) into
shoes (65) to
secure
coil (63).
Tighten screws (62) evenly.
Using a 3/4” open end wrench, install
washers (61 and 60) and nut (59).
Go to sheet 11
5-11
|
