| |
TM 10-3930-643-34
ELECTRICAL SYSTEM MAINTENANCE.
5-1.
Starting Motor. (Sheet 6 of 15)
DISASSEMBLY
34.
35.
36.
37.
38.
39.
NOTE
Remove coil only if testing and
inspection indicate replacement is
necessary.
Using a 3/4” open end wrench, remove
nut (59), washer (60) and washer (61)
from starting motor housing (70).
NOTE
In steps 35 thru 37, support coil
by hand or use pole spreader to
prevent distortion.
Using cross tip screwdriver,
remove
eight screws (62).
Bend up three tabs on commutator end
of coil (63) and pull lead
assembly
of coil (63) through starting
motor
housing (70).
If necessary,
remove
coil (63),
insulator (64), four shoes (65)
and
two plates (66).
Remove washer (67) and insulator
bushing (68) from coil (63).
Using diagonal cutting pliers,
cut
leads and remove terminal stud (69).
Remove only if stud is bent or
threads are damaged.
Go to sheet 7
5-7
|
