| |
TM 10-3930-643-34
ELECTRICAL SYSTEM MAINTENANCE. (cont)
5-1.
Starting Motor. (Sheet 5 of 15)
DISASSEMBLY (cont)
24.
25.
26.
27.
28.
29.
30.
31.
32.
33.
Using snap
ring pliers, remove
retaining
ring (42), preformed
packing (43), shaft (44) and
preformed packing (45) from starting
motor housing
(70).
Discard
preformed packings (43 and 45).
Remove armature (46).
Remove drive (47), lever (48) and
washer (49).
Using long round nose pliers, remove
plug (50).
Using a 7/16” open end wrench, remove
five bolts (51).
Separate items 52 thru 58 as an
assembly.
Using a flat tip screwdriver, remove
preformed packing (52), seal (53) and
washer (54) from lever housing (58).
Discard preformed packing (52) and
seal (53).
Using an electric drill, drill hole
to pry out cap (55) and wick
(56).
Discard cap (55) and wick (56).
Removal of bearing from lever
housing will cause destruction of
bearing.
Remove
only if
inspection indicates removal is
necessary.
Inspect bearing (57).
Replace if
cracked, broken, grooved or scored.
If necessary, press out bearing (57)
using suitable driver and press.
Go to sheet 6
5-6
|
