TM  10-3930-643-34 ELECTRICAL  SYSTEM  MAINTENANCE. 5-1. Starting Motor. (Sheet 2 of 15) DISASSEMBLY 1. Using a flat tip screwdriver, remove plug (1), gasket (2) and locknut (3) from starting motor housing (70). Discard gasket (2) and locknut (3). Hold plunger (10) when turning locknut (3). 2. Using slip joint pliers, remove items 4 thru 10 as an assembly. 3. Compress  spring (6) and remove retaining  ring  (4),  recessed washer (5), spring (6), recessed washer (7), bellows (8) and washer (9) from plunger (10). NOTE All wire must be tagged when removed  from  connector. Indicate whether  wire  is  connected  to  pin- type or socket-type connector. 4. Using a 3/4” open end wrench, remove nut (11) and lead assembly (12) from starting motor housing (70). 5. Using a flat tip screwdriver, remove plug (13), gasket (14), plug (15) and gasket (16). Discard gaskets (14 and 16). 6. Remove two screws (17). Screws (17) may be reached through ports of plugs (13 and 15). Go to sheet 3 5-3