| |
TM 10-3930-643-34
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE. (cont)
4-15.
Turbocharger and Piping. (Sheet 4 of 6)
INSTALLATION
12.
Using a 15/16” socket and socket
wrench handle, install elbow
(20),
two washers (19), bolts (18), washer
(17) and bolt (16) in top, left side
of engine.
13.
Apply anti-seize compound to seals
(15 and 13).
14.
15.
16.
17.
Apply liquid gasket to hose at inlet
connection of turbocharger.
Install seal (15), bushing (14), seal
(13) and turbocharger (12).
Using a flat tip screwdriver, install
hose (10), pipe (11), clamps (9 and
8), hose (7) and clamps (6 and 5).
Do not tighten clamps (9,8,6 and 5).
Connect turbocharger inlet hose,
position and tighten clamp (4).
Turbocharger must be primed prior
to starting the engine.
Failure
to follow this procedure
could
result in damage to
turbocharger
and/or engine.
18.
Apply four or five ounces of clean
lubricating oil into the oil inlet
opening of
the turbocharger to
lubricate the turbocharger bearings
during initial start up.
Go to sheet 5
4-104
|
