| |
TM 10-3930-643-34
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE.
4-15.
Turbocharger and Piping. (Sheet 3 of 6)
CLEANING/INSPECTION
7.
Clean hoses (7 and 10) with cloth
moistened with detergent.
Dry cleaning solvent P-D-680, used
for cleaning parts, is toxic and
flammable.
Use only in well
ventilated areas.
Wear protective
goggles and gloves. Do not smoke
or allow open flames or sparks in
areas where cleaning solvent is
used or stored.
Avoid contact
with eyes, skin or clothing. If
contact with eyes is made,
flush
with cold water and seek medical
attention immediately.
If contact
with skin or clothing is
made,
flush with cold water.
If you
become dizzy while using cleaning
solvent,
get
fresh
air
immediately.
COMPRESSED AIR HAZARD
Compressed air used for cleaning
purposes will not exceed 30 psi.
Use only with effective chip
guarding and personal protective
equipment (goggles/shield, gloves,
etc.).
8.
Clean exterior of turbocharger (12)
with cloth moistened with cleaning
solvent P-D-680.
Allow to air dry.
9.
Clean all other parts with cleaning
solvent P-D-680.
Dry thoroughly
with compressed air.
Refer to
paragraph 2-8.
10.
If turbocharger fails,
check for
small parts dropped into exhaust
manifold.
11.
Inspect all other parts. Refer to
paragraph 2-9.
Go to sheet 4
4-103
|
