TM  10-3930-643-34 ENGINE,  FUEL,  EXHAUST  AND  COOLING  TROUBLESHOOTING  AND  MAINTENANCE.  (cont) 4-15. Turbocharger and Piping. (Sheet 2 of 6) REMOVAL 1. Using  a  9/16  socket  and  socket  wrench handle,  remove  exhaust  manifold  (1) from top, left side of engine, refer to paragraph 4-11. NOTE Tag all hose and tube assemblies before disconnecting to aid in installation. 2. Using 1/2” and 9/16” sockets and a socket  wrench  handle,  remove  turbo- charger oil lines (2 and 3) from left side of engine, refer to TM  10-3930-643-20. 3. Using  a  flat  tip  screwdriver,  loosen clamp  (4)  and  disconnect  turbocharger inlet hose. 4. Remove clamps (5 and 6), hose (7), clamps (8 and 9), hose (10) and pipe (11). 5. Remove  turbocharger  (12),  seal  (13), bushing (14) and seal (15). 6. Using a 15/16” socket and socket wrench  handle,  remove bolt (16), washer (17), two bolts (18), washers (19) and elbow (20). Go to sheet 3 4-102