ENGINE,  FUEL,  EXHAUST  AND  COOLING 4-14. Fuel Injection Pump, Cover REMOVAL TROUBLESHOOTING Plate,  Adapter 6. Using a 1/2”   open  end  wrench,  remove bolt (17) and washer (18). 7. Using a 7/16”   socket,  socket wrench handle and a 7/16” open end wrench, remove nut (19), bolt (20) and two straps (21). 8. Using 3/4” open end wrench, remove hose assembly (22). Cap port on fuel injection pump (36). 9. Using  a  flat  tip  screwdriver,  loosen clamp (23). 10. Disconnect hose (24). 11. Using a 1/2”   socket  and  socket  wrench handle, remove five bolts (25) and washers (26). 12. Remove three nuts (27), washers (28), bolts (29) and washers (30). 13. Support fuel injection pump (36) and using a 1/2”   socket,  socket wrench handle and a 1/2” open end wrench, remove nut (31), washer (32), bracket (33), bolt (34) and washer (35). TM  10-3930-643-34 AND MAINTENANCE. and Drive Gears. (Sheet 3 of 9) 14. Remove  fuel  injection  pump  (36),  then using a gasket scraper  or putty knife, remove gasket (37), cover (38) and gasket (39). Discard  gaskets  (37 and  39). Remove  all  gasket  material from  mounting  surfaces. pump is If the same fuel injection to be installed, DO NOT rotate the pump drive shaft after the pump has been  removed. Failure  to  follow this procedure will damage the fuel injection  pump  timing. Go to sheet 4 4-95