| |
TM 10-3930-643-34
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE.
4-8.
Oil Filter Base. (Sheet 4 of 4)
CLEANING/INSPECTION
9.
Apply test load of 6.12 lb-ft to
spring (9).
10.
Measure test length of spring
(9).
Test length should be 0.927 inches.
11.
Replace spring (9) if free or test
length does not meet specifi-
cations.
12.
Inspect all other parts. Refer to
paragraph 2-9.
INSTALLATION
13.
Using a 5/8 socket, socket
wrench
handle and torque wrench, install
check valve (10), spring
(9), new
gasket (8) and plug (7).
Tighten
plug (7) to 50 lb-ft.
14.
Using a 3/4 open end wrench,
coat
threads of elbow (6) with sealant and
install elbow (6).
NOTE
On vehicles S/N 2001 and above,
slide gasket and oil filter behind
oil sampling valve.
15.
Using a 9/16 socket and socket
wrench handle, install
new gasket
(5), oil filter base (4), six washers
(3) and bolts (2) on front, left side
of engine.
16.
Using a 3/4 open end wrench, connect
turbocharger oil line (1).
NOTE
Return M10A Forklift to original
equipment condition.
END OF TASK
4-67
|