| |
TM 10-3930-643-34
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE. (cont)
4-5.
Vibration Damper. (Sheet 4 of 4)
INSTALLATION
8.
Using sleeve installer, press wear
sleeve (9) on vibration damper (6).
9.
Install spring washer (8) in bottom,
front of engine.
l Do not attempt to install
vibration damper cold.
l Do not heat vibration damper for
10.
11.
12.
13.
14.
15.
more than one hour to avoid
damage to the elastic member.
Heat vibration damper (6) in boiling
water.
Lightly coat key (7) and keyway area
with No. 2 Permatex sealant.
Using a ball peen hammer, install key
(7) and vibration damper (6).
After installing
vibration damper
(6), remove excess No. 2 Permatex
sealant from mounting surfaces.
Using a 3/4” socket and socket wrench
handle, install plate (5) and three
bolts (4).
Tighten three bolts
(4)
to 125 lb-ft.
Using a 9/16” socket and socket
wrench handle, install
plate (3),
four washers (2) and bolts (1).
NOTE
Return M10A Forklift to original
equipment condition.
END OF TASK
4-50
|
