| |
TM 10-3930-643-20
PREPARATION FOR MOVING
16-4.
Storage. (Sheet
Preparing for Storage
When the M10A Forklift
AND STORAGE,
1 of 4)
is not to be used for a period of time, store it in a
dry and protected place. Leaving equipment outdoors, exposed to the elements,
w i l l s h o r t e n i t s l i f e.
To place the vehicle in storage for 30 days or more, the following procedure
must
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
be performed:
Wash and clean the M10A Forklift
Lubricate all points as shown in
thoroughly.
LO 10-3930-643-12.
Move vehicle to storage location.
If, during the time of operation, the cooling system was filled with water
only, and now will be exposed to freezing temperatures, drain and
r e f i l l
with antifreeze. Refer to paragraph 4-27.
Service the air cleaner. Refer to paragraph 4-17.
Drain water from fuel tank and fill with approved diesel fuel.
R e f e r to
paragraph 4-19.
Seal engine air intake, exhaust outlet, electrical components, fuel tank
vent line and breathers on the crankcase and
hydraulic
r e s e r v o i r to
prevent dirt and moisture from entering.
Remove batteries and store in a cool dry place (32° to 50° F) to keep them
from discharging.
Be sure they are fully charged.
Check batteries once a
month for water level and specific gravity.
Never allow them to run below
3/4 full charge.
Coat all machined, unpainted surfaces with chassis grease to prevent rust.
O i l a l l c o n n e c t i o n s , j o i n t s , n u t s , p i n s , s h a f t s a n d b u s h i n g s o f t he
control linkage which do not have lubrication fittings.
If the fork is detached for storage, secure the cylinder to the machine to
avoid damage.
If tires are left on M10A Forklift, jack vehicle up and place on blocks,
leaving tires suspended. Deflate and cover tires.
16-7
|