| |
TM 10-3930-643-20
HYDRAULIC SYSTEM TROUBLESHOOTING AND MAINTENANCE.
14-3. Fork Control Lever Assemblies. (Sheet 2 of 7)
REMOVAL
Make sure that vehicle will not
r o l l o r s h i f t .
Secure with wood
b l o c k s .
DEATH
or serious injury may result by
your failure
t o f o l l o w t h i s
procedure.
NOTE
The following is a maintenance
procedure for the three move-
ment lever. The maintenance
procedure for the tilt and lift
l e v e r s i s i d e n t i c a l.
Measure the length of rod from
the bottom of one clevis to the
bottom of the other clevis to
aid in adjustment procedure.
1.
Using long round nose pliers, remove
cotter pin (1) and pin (2) from
under right side of cab. Discard
c o t t e r p i n ( 1 ).
2.
Using a 1/2 open end wrench, loosen
nut (4).
3.
Remove clevis (3) and nut (4).
4.
Using long round nose pliers, remove
cotter pin (5) and pin (6). Discard
cotter pin (5).
5.
Using a 1/2 open end wrench, loosen
nut (8).
6.
Remove clevis (7), nut (8) and rod
( 9 ).
Go to sheet 3
14-9
|