| |
TM 10-3930-643-20
BODY, CAB, HOOD AND HULL MAINTENANCE.
12-10.
Door (S/N 2001 and above). (Sheet 4 of 5)
CLEANING/INSPECTION
19.
Clean all other parts with
cleaning solvent P-D-680.
Dry
thoroughly with compressed air.
Refer to paragraph 2-8.
20.
Inspect all parts.
Refer to
paragraph 2-9.
If seals must
be replaced, cut from bulk seal
NSN 5330-01-274-2805 as follows:
Seal (11) cut 11-1/2 feet long.
Seal (15) cut 24 inches long.
ASSEMBLY
21.
22.
23.
24.
25.
26.
27.
28.
29.
Install new sound suppression (30)
on inside of lower half of door (10).
Install molding (29) on top edge of
storage compartment.
Using a flat tip screwdriver, install
latch (28), four washers (27) and
screws (26).
Using a flat tip screwdriver and a
3/8” open and box end wrench, install
washer (24), nut (23) and bumper
( 2 2 ).
Install door handle (21), lockwasher
(20), washer (19), nut (18) and
screw (17) on outside of lower half
of door (10).
Using a flat tip screwdriver, install
screw (16) in handle (21).
Install seal (15) on top edge of
lower half of door (10).
Install latch (14), four washers
(13) and screws (12) on inside upper
half of door (6).
Install window, refer to paragraph
12-8.
Go to sheet 5
12-50
|
