| |
FRAME AND TOWING ATTACHMENTS TROUBLESHOOTING AND MAINTENANCE.
11-2.
Roll Over Protective Structure. (S/N 2000 and below) (Sheet 7 of 9)
ASSEMBLY
28.
29.
30.
31.
32.
33.
34.
35.
36.
TM 10-3930-643-20
Using a 9/16” socket and socket
wrench handle, install plate
(45)
and two screws (44) on lower front,
inner right side of ROPS (18).
Install new channels (43 thru 40) in
right side of ROPS (18).
Apply
adhesive backing of
c h a n n e l s ( 4 3
thru 40) to clean, dry surface.
Install panel (39), eight washers
(38) and bolts (37).
I n s t a l l s e a l ( 3 6 ) o n r i g h t s i de
window frame in ROPS (18).
Using a 7/16” socket, socket wrench
handle and box and open end wrench,
install two bars (35), six
washers
(34), bolts (33) and nuts (32) in
rear, upper left and right sides of
ROPS (18).
Install seal (31) on window frame in
rear center window in ROPS (18).
Install protector (30) in seal (31).
Press seal (31) at tab “A” into tab
“B”.
A mild soap solution on tab
“A” will help to make installation
e a s i e r .
Install seal (29) on protector (30).
Go to Sheet 8
11-9
|
