| |
TM 10-3930-643-20
WHEEL TROUBLESHOOTING AND MAINTENANCE. (cont)
9-2.
Wheel Assembly and Tire. (Sheet 6 of 8)
CLEANING/INSPECTION
14 l
Wipe bead edges of tire
( 8 ) w i t h
clean
c l o th
moistened
with
d e t e r g e n t .
Dry cleaning
solvent P-D-680,
used for cleaning parts, is toxic
and flammable. Use only in well
ventilated
areas.
Wear
protective goggles and gloves.
Do not smoke or allow open flames
or sparks in areas where cleaning
solvent is used or stored.
Avoid
contact with
eyes,
s k i n o r
c l o t h i n g.
If contact with eyes
is made, flush with cold water
and
s e e k m e d i c a l a t t e n t i on
immediately.
I f c o n t a c t w i t h
skin or clothing is made,
f l u sh
with cold water.
If you
become
dizzy
while
using
cleaning
s o l v e n t , g e t f r e s h
a ir
immediately.
• COMPRESSED AIR HAZARD
Compressed air used for cleaning
purposes will not exceed 30 psi.
U s e o n l y w i t h e f f e c t i v e c h ip
guarding and personal protective
equipment
( g o g g l e s / s h i e l d,
g l o v e s , e t c . ) .
15.
Clean all other parts with cleaning
solvent P-D-680.
Use wire brush to
remove rust,
c o r r o s i o n or
o l d
rubber.
Dry
thoroughly with
compressed air.
16.
Inspect tire (8), replace if casing
fabric or cord is damaged.
Remove
any foreign material
f r o m i n s i d e
tire (8) or between tread cleats.
Go to sheet 7
9-8
|
