| |
TM 10-3930-643-20
PROPELLER AND PROPELLER SHAFTS TROUBLESHOOTING AND MAINTENANCE. (cont)
7-2 .
Propeller Shaft (Torque Converter to Transmission). (Sheet 6 of 6)
INSTALLATION
18.
19.
20.
Using snap ring pliers,
i n s t a ll
retaining ring (7), yoke (6), washer
(5) and new locknut (4) on upper
transmission shaft.
Use a
torque
wrench and 1-7/16” socket to tighten
locknut (4) to 20 lb-ft.
I n s t a l l i t e m s 2 0 t h r u 8 a s an
assembly with four bolts
(3)
on
transmission input yoke (6).
Use a
torque wrench and 1/2”
s o c k e t to
tighten bolts (3) to 20 lb-ft.
Install four bolts (2) and four new
l o c k n u t s ( 1 ) o n t o r q u e c o n v e r t er
output yoke. Use a torque wrench and
1/2” socket to tighten bolts (2) to
2 0 l b - f t.
Grease all fittings in
drive shaft assembly, refer to LO 10-
3930-643-12.
NOTE
Return M10A Forklift to original
equipment condition.
END OF TASK
7-8
|
