| |
TM 10-3930-643-20
ELECTRICAL SYSTEM TROUBLESHOOTING AND MAINTENANCE.
5-11.
Starter Lockout Relays. (Sheet 3 of 5)
INSTALLATION
8.
Using a 7/16” open end wrench, 7/16”
socket and socket
wrench handle,
install relay (13), two bolts (12),
lock washers (11) and nuts (10) on
right side of
f r a m e i n e n g i ne
compartment.
9.
Connect wire assemblies (9 and 8).
10.
Install relay (7), two bolts (6),
lock washers (5) and nuts (4).
11.
Connect wire assemblies (3 and 2).
TESTING
Before proceeding with electrical
test, refer to Chapter
2
for
i n i t i a l
setup
i n s t r u c t i o n s.
Failure to follow this procedure
could cause damage to equipment.
NOTE
The following is a test procedure
for one starter lockout
r e l a y .
T h e t e s t p r o c e d u r e f o r t h e
remaining starter lockout
relay
i s i d e n t i c a l .
12.
13.
14.
Using 1/2” open end wrench, connect
battery negative cable.
Test upper contact opening voltage
on relay (7) on right side of frame
in engine compartment.
Connect red lead on multimeter to
terminal (14) and black lead to
terminal (15).
Go to sheet 4
5-95
|
