| |
TM 10-3930-643-20
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE.
4-24.
Ether Start Valve and Mounting. (Sheet 4 of 6)
CLEANING/INSPECTION
17.
18.
19.
20•
Clean tubes (22 and 25) with mild
detergent and water solution.
TOXIC/FLAMMABLE
Dry cleaning
solvent P-D-680,
used for cleaning parts, is toxic
and flammable. Use only in
well
ventilated areas. Wear protective
goggles and gloves. Do not smoke
or allow open flames or sparks in
areas where cleaning solvent is
u s e d o r s t o r e d . A v o i d c o n t a c t
w i t h e y e s , s k i n o r c l o t h i n g . If
contact with eyes is made, flush
with cold water and seek medical
attention immediately. If contact
with skin or clothing is
made,
flush with cold water.
I f y o u
become dizzy while using cleaning
s o l v e n t , g e t
fresh
a ir
immediately.
Do not permit cleaning solvent
P-D-680 to contact
e l e c t r i c a l
l e a d s o n e t h e r s t a r t v a l v e .
Cleaning solvent will deteriorate
nonmetal parts.
Clean all metal parts with cleaning
solvent P-D-680.
Dry thoroughly.
Refer to paragraph 2-8.
Inspect tubes (22 and 25). Replace
if cracked or split.
Check inside
diameter for
blockage.
Remove
b l o c k a g e o r r e p l a c e t u b e . If
necessary, to replace tubes,
r e f er
to Appendix D. Tube (22) is 33”
long and tube (25) is 23” long.
I n s p e c t a l l p a r t s . R e f e r t o p a r a-
graph 2-9.
Go to sheet 5
4-95
|
