| |
TM 10-3930-643-20
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE. (cont)
4-23.
Fuel Filters and Mounting. (Sheet 3 of 4)
CLEANING/INSPECTION
7.
Clean all parts with cleaning
solvent P-D-680.
Wipe thoroughly
with clean cloth.
Refer to
paragraph 2-8.
8 .
I n s p e c t a l l p a r t s . R e f e r t o p a r a -
graph 2-9.
INSTALLATION
9.
10.
11.
12.
13.
Using a 5/8” open en wrench
install elbows (15, 14, 13 and 12)
on head (11).
Using a 9/16w socket, socket wrench
handle and a 5“ extension,
i n s t a l l
head (11), three washers (10) and
screws (9) on right side of engine.
Using a 3/4” open end wrench and a
3 / 4 ” b o x a n d o p e n e n d w r e n ch
(tubing), connect hose assemblies
(8, 7, 6 and 5).
Install new tie straps (4 and 3)
securing hose assemblies (7 and 8).
Install new final filter element (2)
and new primary filter element (1).
Apply light coating of engine oil to
seal surface of elements (2 and 1).
Turn elements (2 and 1) on head (11)
until seal just makes contact.
Hand
tighten elements (2 and 1) and add
an additional 1/4 to 1/2 turn.
Do not overtighten elements.
VENTING
14.
To vent the system use 8“ slip joint
pliers, loose wing nut (16) on right
s i d e o f e n g i n e .
Go to sheet 4
4-90
|
