| |
TM 10-3930-643-20
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE. (cont)
4-16. Air Cleaner Connections. (Sheet 6 of 9)
CLEANING/INSPECTION (cont)
2 4 , I n s p e c t a l l p a r t s.
Refer to paragraph 2-9.
25.
Replace hose (17) if required.
INSTALLATION
NOTE
During
i n s t a l l a t i o n p r o c e d u r e,
apply Loctite 592 to all threaded
connections.
26.
27.
28.
29.
30.
31.
Using a 9/16 open and box end wrench,
install coupling (23) on air cleaner
assembly (24).
Install plug (22), but do not tighten.
Install clamps (20 and 19) on hose
(21) and clamps (16 and 15) on h o se
( 1 7 ) .
Install hose (21) with clamps (20
and 19) to large end Of air cleaner
pipe assembly (18) and hose (17)
with clamps (16 and 15) to small end
of air cleaner pipe assembly (18).
Install air cleaner pipe assembly
( 1 8 ) o n a i r c l e a n e r o u t l e t a nd
r o t a t e a i r c l e a n e r p i p e a s s e m b ly
(18) down to turbocharger inlet.
Slide hose (17) and clamps (16 and
15) over turbocharger inlet and
using a medium flat tip screwdriver,
tighten clamps (20, 19, 16 and 15).
Go to sheet 7
4-64
|