| |
TM 10-3930-643-20
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE.
4-10.
Oil Lines and Fittings. (Sheet 4 of 10)
REMOVAL
Turbocharger Oil Lines
12.
13.
14.
15.
16.
Using a 9/16” open end wrench,
loosen nuts (46 and 47) and remove
tube
assembly
injection pump
engine.
Using a 9/16”
remove
elbow
compressor.
( 2 2 ) f r o m f u e l
on right
s i d e o f
open
end
wrench,
( 2 3 ) f r o m
a ir
Using a 1/2” open end wrench,
remove
tee (24) from engine.
Using a 1/4” flat tip screwdriver,
remove screw (25), nut
( 2 6 ) a nd
clamp (27) from
t u r b o c h a r g e r at
left, rear side of engine.
Cut and discard tie strap (28).
Go to sheet 5
4-35
|
