TM 10-3930-638-24&P 4 - 4 .     T R A N S M I S S I O N     M A I N T E N A N C E     ( c o n t) g.  Low  Clutch  Assembly  (cont). Low clutch shaft inspect drum and bleed valve assembly  (20) Inner clutch discs Inspect (12), outer clutch discs  (13) Piston return Inspect spring (16) Bearings (2, 4, 8) Inspect All other parts STEP LOCATION ITEM ACTION REMARKS INSPECTION 20 Inspect teeth for wear, pits, cracks, chips, nicks and scores. Inspect body for cracks, wear, distortion and damage. If any of these conditions are observed, replace drum and bleed valve assembly 21 Replace disc if worn, cracked, damaged or broken 22 Replace if cracked, worn, distorted, broken or permanently set 23 Inspect rollers and cages for wear, chips, nicks and damage. Replace if any of these conditions are observed. Dip bearings in clean light oil and wrap in clean lintless cloth or paper 24 Inspect Inspect  for  wear,  damage,  cracks  and  dis- tortion. If any of these conditions are observed,  replace  part REASSEMBLY 25 Outer clutch piston Install and size Lubricate oil seal with OE10 (refer to seal  (18) current  lubrication  order).  To  size seal,  rotate  clutch  piston  while holding a round object against new seal as shown. Rotate clutch piston until seal is flush with outer diameter  of  clutch  piston Change  1 4-211